American library books Β» Study Aids Β» Manual of Military Training by James A. Moss (best value ebook reader .TXT) πŸ“•

Read book online Β«Manual of Military Training by James A. Moss (best value ebook reader .TXT) πŸ“•Β».   Author   -   James A. Moss



1 ... 97 98 99 100 101 102 103 104 105 ... 143
Go to page:
a small cone and small group, and poor shots a large cone and large group.

1413. Beaten zone. The intersection of the cone of dispersion with the surface of the ground is called the beaten zone.

If the surface of the ground is horizontal, the form of the beaten zone is that of an ellipse with its longer axis in the direction of the line of fire, as shown in Fig. 45.

Fig. 45 Fig. 45

In view of the fact that at the long ranges the angle of fall of the bullets is much greater than at short ranges, it follows that at short ranges the elliptical figure (beaten zone) is much more elongated than at long ranges. In other words, the longer the range, the shorter is the depth of the beaten zone. This is shown in Fig. 45.

1414. Uncertainty and ineffectiveness of long-range fire. It follows from what has been said, that as the range increases the length of the beaten zone decreases,β€”that is, a less depth of ground is held under fire. That being the case, if an error is made in sight setting due, for example, to an incorrect estimate of the range, the proportionate loss of fire effect due to misplacement of the center of impact will be greater as the beaten zone is less,β€”that is, as the range is greater.

Furthermore, the difficulty of exact range determination increases with the distance, the two influences combining to make long-range fire uncertain and usually ineffective.

1415. Zone of effective fire. That portion of the ground which contains the best 75 per cent of the shots in the beaten zone, is called the zone of effective fire.

Effectiveness of Fire

1416. Factors involved. The effectiveness of fire depends upon these three factors:

(1) The percentage of hits made; (2) The number of targets hit; (3) The time of execution.

That is to say, the effectiveness of fire is determined by the number of enemies disabled or targets hit in a given time.

1417. Percentage of hits. By the percentage of hits is meant the proportion of all the bullets fired that hit the targets. For example, if 1000 bullets are fired and 750 hit the targets, then the percentage of hits is 75.

The percentage of hits depends upon the dispersion, and this is influenced by the precision of the arm, the range, the visibility of the target, the atmospheric conditions, the training and instruction of the troops, and upon their physical and moral state at the time. In addition, the percentage of hits also depends upon the character of the ground as favoring ricochet hits, upon the correct estimation of the range and the proper designation of the target.

1418. Number of targets hit. The number of targets hit,β€”that is, the distribution of fire,β€”may be affected by varying degrees of visibility, as men instinctively choose the more conspicuous marks as aiming points. Under any circumstances, a poor distribution of the hits made will be due to an absence of proper instructions from the leaders; or, in other words, to poor control, or else to a want of understanding or lack of obedience on the part of the men.

1419. Time of execution. The time of execution is important in that the gaining of fire superiority is dependent less upon obtaining high percentages of hits than upon making an absolutely large number of hits in a unit of time. There is necessarily a limit to the rapidity of fire which, if exceeded, will result in some loss of accuracy. With targets of a fair degree of visibility, the following may be taken as standard rates of fire for troops who have been given suitable training in target practice:

200 yards   10 shots per minute. 300 yards   400 yards     500 yards   7.5 shots per minute. 600 yards   700 yards     800 yards   5 shots per minute. 900 yards   1,000 yards     Greater ranges, 3 shots per minute.

The rates given should not exclude higher rates of fire in the case of large and conspicuous targets. On the other hand, when objectives, or marks used as aiming points, are very indistinct, the requirement of correct aiming imposes rates of fire somewhat lower than the standard rates given even for well-instructed men.

With imperfectly trained men who have not fully acquired the habit of using aimed fire only, and who are lacking in the manual dexterity required for executing the standard rates of fire, the maximum rate can not well exceed six shots per minute without incurring the danger of lapsing into unaimed fire.

Fatigue and exhaustion, the results of marches or prolonged firing, have a detrimental influence and tend to lower the rates of effective fire.

Influence of Ground

1420. Defilade. If we will consider a bullet just grazing the top of an impenetrable obstacle (like "A," Fig. 46), the space from the top of such obstacle to where the bullet strikes the ground (space B E, Fig. 46) will be protected from fire. Such space is called, "defiladed space." Its extent will, of course, depend on the height of the obstacle, the curvature of the trajectory and the slope of the ground in rear of the obstacles.

Fig. 46 Fig. 46

Between B and D, a soldier standing would be completely protected; between D and E, he would be only partially protected. To obtain complete protection between D and E the soldier would have to assume the kneeling or prone position, depending on how far away from D he was.

By cover is meant effective defilade from the enemy's fire.

By concealment is meant screening from view but not necessarily protection from fire.

1421. Rising and falling ground. The influence of the ground upon the effect of fire is at once seen by studying Fig. 44.

If the ground rises, as shown by B O and A O, the depth of the beaten zone (and consequently the effect of fire) decreases. On the other hand, if the ground falls (up to a certain point), the depth of the beaten zone (and consequently the effect of fire) increases.

1422. Depth of beaten zone affects only targets having depth. It should be remembered that depth of beaten zone can affect only targets which have depth.

On a target in the form of a line,β€”a line of skirmishers, for example,β€”the depth of the beaten zone has no effect one way or the other. If such a target, however, is backed up by supports and reserves, the depth of the beaten zone may have a decided effect on them, depending upon their distance in rear of the line forming the target and the slope of the ground in rear of such target.

In this connection, attention is invited to Fig. 47, which shows how in the case of a fire delivered from a height at a target on a horizontal plane beneath, the beaten zone is shortened and consequently the fire effect decreased.

Fig. 47 Fig. 47

An example of increasing the depth of beaten zone is seen in Fig. 48, which shows a fire delivered from low ground at a target on the edge of a plateau or crest of a ridge from which the ground slopes to the rear.

Fig. 48 Fig. 48

1423. Grazing fire. Shots which pass over a crest with an angle of fall conforming, or nearly conforming, to the slope of the ground beyond the edge of the crest (as shown in Fig. 48), are called grazing shots and fire so delivered is called grazing fire.

1424. Diminution or increase in fire effect due to rising and falling ground. In connection with the diminution or increase in fire effect due to rising and falling ground, attention is invited to the following:

1. If the ground slopes upward to the rear from a firing line, the supports may be placed closer without increasing the danger from fire aimed at the firing line.

2. When the ground slopes down and to the rear from the firing line forming the target, the supports must be posted at a greater distance in rear, unless the slope is so much greater than the angle of fall of the hostile bullets that a defiladed space is created in which no bullets strike, in which case the supports may be brought up close to the crest.

3. On ground rising with respect to the line of sight, column targets (i. e., having depth) will suffer greater losses than lineal targets.

4. On ground falling with respect to the line of sight, the reverse slope of hills or the level grounds of plateaus, line targets will suffer the greater losses.

1425. Ricochet shots. When a bullet strikes any surface and is deflected it is called a ricochet shot.

Not only do bullets that ricochet usually tumble after striking, but they are also mutilated, so that wounds inflicted by ricochet hits are usually severe.

The most favorable ground for ricochets is a smooth, hard, horizontal surface, the aim being low, the chance of ricochets in sand is very slight.

1426. Occupation of ground. The question of the occupation of ground presents these two aspects:

1. What firing positions may be chosen which will tend to increase the losses of the enemy?

2. What positions may be chosen and formations adopted to minimize our own losses?

The selection of a defensive position presents this question: Shall it be near the crest or well down the slope?

A position well down the slope

Advantages:

1. The depth of the beaten zone for fire delivered from the position is increased and the upper portion of the cone of fire will include the supports and reserves advancing to reΓ«nforce the hostile firing line. That is to say, the fire will be a grazing fire.

2. It eliminates dead spaces that might otherwise exist at the bottom of the slope.

3. The hostile fire being directed against a point well down the slope, the high ground in rear will interpose as a defilade and intercept the upper portion of the cone of fire which might otherwise take effect on the supports and reserves behind the crest.

Disadvantages:

1. It makes withdrawal difficult in case it becomes necessary to fall back.

2. It is difficult to reΓ«nforce the firing line.

A position near the crest

Advantages:

1. It favors observation of the enemy.

2. It makes withdrawal easy in case it becomes necessary to fall back.

3. It is easy to reΓ«nforce the firing line by the supports advancing from behind the crest.

Disadvantages:

1. The depth of the beaten zone is decreased and consequently the cone of fire will probably not include the supports and reserves advancing to reΓ«nforce the hostile firing fire. In other words, the fire will be a plunging fire.

2. It is likely to result in dead spaces at the bottom of the slope.

3. It affords a good target for the hostile artillery.

Whether or not a position near the crest or a position down the slope should be chosen, depends, in each case, upon circumstances.

For instance in a rear guard action, where a determined stand is not contemplated, a position near the crest would be occupied. On the other hand, if a determined stand were contemplated, the terrain offered good opportunity for the delivery of an effective grazing fire, and we had reason to believe that we were going to be subjected to heavy artillery fire, a position at the foot of the slope would be selected.

However, it may be said that, in general, a defensive position should be near the bottom of the slope.

1427. Gentle reverse slopes. From the point of view of avoiding losses, all gentle reverse slopes are dangerous and are

1 ... 97 98 99 100 101 102 103 104 105 ... 143
Go to page:

Free e-book: Β«Manual of Military Training by James A. Moss (best value ebook reader .TXT) πŸ“•Β»   -   read online now on website american library books (americanlibrarybooks.com)

Comments (0)

There are no comments yet. You can be the first!
Add a comment