Manual of Military Training by James A. Moss (best value ebook reader .TXT) 📕

CHAPTER IV

SIGNALING

Signals and Codes

General Service Code. (International Morse Code.)

861. Used for all visual and sound signaling, radiotelegraphy, and on cables using siphon recorders, used in communicating with Navy.

A · –           B – · · ·       C – · – ·       D – · ·         E ·             F · · – ·       G – – ·         H · · · ·       I · ·           J · – – –       K – · –         L · – · ·       M – –           N – ·           O – – –         P · – – ·       Q – – · –       R · – ·         S · · ·         T –             U · · –         V · · · –       W · – –         X – · · –       Y – · – –       Z – – · ·       NUMERALS 1 · – – – –     2 · · – – –     3 · · · – –     4 · · · · –     5 · · · · ·     6 – · · · ·     7 – – · · ·     8 – – – · ·     9 – – – – ·     0 – – – – –     PUNCTUATION Period · · · · · ·   Comma · – · – · – · Interrogation · · – – · ·  

 

THE MORE IMPORTANT CONVENTIONAL FLAG SIGNALS

For communication between the firing line and the reserve or commander in rear. In transmission, their concealment from the enemy's view should be insured. In the absence of signal flags the headdress or other substitute may be used.

(See par. 96 for the signals.)

Wigwag

Signaling by flag, torch, hand lantern, or beam of searchlight (without shutter)[6]

862. 1. There is one position and there are three motions. The position is with flag or other appliance held vertically, the signalman facing directly toward the station with which it is desired to communicate. The first motion (the dot) is to the right of the sender, and will embrace an arc of 90°, starting with the vertical and returning to it, and will be made in a plane at right angles to the line connecting the two stations. The second motion (the dash) is a similar motion to the left of the sender. The third motion (front) is downward directly in front of the sender and instantly returned upward to the first position. This is used to indicate a pause or conclusion.

2. The beam of the searchlight, though ordinarily used with the shutter like the heliograph, may be used for long-distance signaling, when no shutter is suitable or available, in a similar manner to the flag or torch, the first position being a vertical one. A movement of the beam 90° to the right of the sender indicates a dot, a similar movement to the left indicates a dash; the beam is lowered vertically for front.

3. To use the torch or hand lantern, a footlight must be employed as a point of reference to the motion. The lantern is more conveniently swung out upward to the right of the footlight for a dot, to the left for a dash, and raised vertically for front.

4. To call a station, make the call letter until acknowledged, at intervals giving the call or signal of the calling station. If the call letter of a station is unknown, wave flag until acknowledged. In using the searchlight without shutter throw the beam in a vertical position and move it through an arc of 180° in a plane at right angles to the line connecting the two stations until acknowledged. To acknowledge a call, signal "Acknowledgment (or) I understand (——front)" followed by the call letter of the acknowledging station.

Notes on Wig-wagging

5. In order to avoid the flag wrapping itself about the staff, stand facing the receiving station, with feet apart. Hold the staff with the left hand at butt and right hand 24 inches from end. In moving flag to the right, bring it down with an outward and inward sweep, and then return it to the vertical. When the tip is farthest down the staff inclines to the right front and as the flag is brought upward it is swept inward and upwards and as it approaches the vertical position it sweeps forward slightly. In moving to the left the motion is similar,—at the lowest point the staff inclines to the left front. A combination of right and left is made with a figure-of-eight motion.

In making "front" the flag is lowered and moved very slightly to the left front and then swept slightly to the right front, making a figure-of-eight.

The body should be twisted and bent at the waist in making the light and left motions.

Care should be exercised in keeping the flag in front of the body in making "front," the figure-of-eight is necessarily very flat.

Do not make letters in a careless slipshod manner.

The Two-arm Semaphore Code

(See Plates I and II)

863. Semaphore signaling may be done with or without flags. Without flags it is rarely dependable beyond 600 yards.

In sending stand with feet apart, squarely facing the receiver.

In making letters which require the use of both arms on the same side of body, twist the body to that side and bend at waist, so as to throw both arms well away from body. But be careful to keep arms in plane of original position of body.

When a letter repeats—bring both hands (if a two-armed letter) to chest after first, then make second.

Do not try to send rapidly so as to exhibit your ability. Remember that the receiver's ability determines the speed to be used. Anyone can send faster than he himself can receive. If you want to display your skill have some one send rapidly to you.

In receiving, if you miss a letter—let it go and get the others. If you miss a word signal—"O" (waving flags or arms) and signal the last word you have received.

Rapidity is secondary to accuracy.

Take the positions for the various letters accurately. The horizontal position should not incline upward nor downward. In making an "L," for example, if the left arm is midway between its proper position and the horizontal it is difficult to tell whether it is L or M.

In making D, J, K, P, T, and V, the arm in the vertical position should be brought exactly in front of the body by carrying the shoulder in almost under the chin, twisting the elbow in until it is directly before the eyes, and the forearm held in the vertical position with the palm to the rear. When so done there is no possibility of this position being mistaken for any other.

"Manila Milkman" may be sent without changing the position of the right hand. In making I, be sure to twist body well to the right in order that the left arm may be seen in the upper slanting position to the right. City and similar words may be so made.

D may be made with either hand.

Be sure how next letter is made before moving hands. Make no false motions.

Acquire accuracy; then try for speed.

"CHOP-CHOP." The "chop-chop" signal is made by placing both arms at the right horizontal (that is, by bringing the left arm up to the position of the right arm as in the figure for letter "B"), and then moving each up and down, several times, in opposite direction, making a cutting motion.

END OF WORD. After each word the "Interval" signal is made.

END OF SENTENCE. After each sentence the chop signal is made twice.

END OF MESSAGE. At the end of a message the chop signal is made three times.

ERROR. Signal "A" several times quickly, followed by interval; then repeat the word.

TO BREAK IN. Signal "Attention."

NUMERALS. Numbers are always preceded by the signal, "Numerals." After "Numerals" has been signaled, everything that follows will be numbers until "Interval" is signaled, after which what follows will be letters.